im thinking of buying a swept side right rear exit tailpipe from gibson performance. the pipe is from a 87-94 ford E150/250 kit. its 3" tubing and looks really sweet.

will the pipe's over- the- axle curve line the pipe up behind the wheel for my '74 123" w.b. E200? i think it should.

im having a muffler shop make some new 2" or 2 1/2" downpipes thru a 3" Y and into a 3" Flowmaster 70 series. just need a tail pipe

thx
mark

Hi Mark,

I say go for it. It might not be a exact fit, but you can have the muffler shop make a few cuts and maybe weld in a straight section or two to get it to fit perfectly.

My plan was is to build a single 3" exhaust tail pipe exiting out the stock location. The only thing different is I was planning on making a dual exhaust system, then after the mufflers, bring the two pipe to a "Y", it into a single 3" tail pipe. I purchased my 3" Mandrel Bend "U" Pipes about 6 years ago to do the exhaust for the van, but I have not gotten around to it.

Vic